Hi everyone,
I recently (mid-December) purchased an Enviro Maxx thanks to the advice of those on the board. So far the unit has worked like a dream and is perfect for the space.
Unfortunately, for the last week or so I have been having an issue getting it started. When I turn the stove on, it begins dropping the pellets into this burn pot and then they ignite like usual. The fire starts and looks normal for a few minutes. Then, after burning for a little while, when the blower would typically turn on, the feeder stops dropping pellets, the fire dies out and the stove turns itself off.
By the way, the third light on the blower speed panel blinks after this process.
After this, if I push the "On" button again, the unit starts back up normally and then will function perfectly until I turn it off again.
Does anyone have any idea why the stove is cycling this way? Any advice is greatly appreciated!
I recently (mid-December) purchased an Enviro Maxx thanks to the advice of those on the board. So far the unit has worked like a dream and is perfect for the space.
Unfortunately, for the last week or so I have been having an issue getting it started. When I turn the stove on, it begins dropping the pellets into this burn pot and then they ignite like usual. The fire starts and looks normal for a few minutes. Then, after burning for a little while, when the blower would typically turn on, the feeder stops dropping pellets, the fire dies out and the stove turns itself off.
By the way, the third light on the blower speed panel blinks after this process.
After this, if I push the "On" button again, the unit starts back up normally and then will function perfectly until I turn it off again.
Does anyone have any idea why the stove is cycling this way? Any advice is greatly appreciated!