flame height

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  1. Justin3356

    Trouble with flame height, Jotul GF 160 DV

    I recently purchased a Jotul GF 160 DV, on LP gas service. The stove is pictured below. The stove is functioning and heating the room. But, the flames are extremely small and almost entirely blue, with the exception of one or two flames. Linked here is a video of the stove operating at the...
  2. R

    Need Help!!! Quadra Fire Edge 60 bad/missed ignition | low flame | fire dies out

    Hi, I have a Quadra Fire Edge 60 pellet stove that was bought by former owner 12 years ago. Recently the stove takes really long time to ignite (probably 2-3 startup cycle to start fire. Possible igniter issue?). But then I noticed the flame is really low and weak which cannot reach the...
  3. R

    Quadra Fire Edge 60 slow ignition and low flame

    Hi, I have a Quadra Fire Edge 60 pellet stove that was bought by former owner 12 years ago. Recently the stove takes really long time to ignite (probably 2-3 startup cycle to start fire). But then I noticed the flame is really low and weak which cannot reach the thermocouple. I tried open the...
  4. Cheeks

    GCI60 insert flame struggles

    Hi, I've had my Harmon GCI60 Pellet Insert for over five years. I feel I know how it works year to year and have always had my settings the same (air rod out about 1.5 inches, fuel trim 5, air trim 3, premium pellet setting) Suddenly this year I seem to be having flame issues. Even on setting...
  5. P

    Heat n Glo I35F - No Flame Adj; How Warm Should it be?

    We had a Heat n Glo I35F installed in Dec 2015. The fan was making a high pitched squeal which was swapped out under warranty. Then, the replacement fan started making a different noise which was attributed to a wire that had somehow come into contact causing a vibration type noise. The fan...
    • Pearsonweb
    • Thread
    • flame height heat amount heat n glo i35 how hot temperature warmth
    • Replies: 7
    • Forum: It's a Gas!
Top Bottom
Back