576 AT breakin in calibration
- Thread starter FireNewbie
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Michael Golden
Feeling the Heat
Run it at varying speeds "In Wood" and don't rev it wide open out of the wood for break in. You can do wfo in the wood just not sustained, that's why I'll pick a good log to buck that gives me 15-25sec to cut through between cuts..while cutting I'll press on it hard sometimes to add a load..
- Status
