I'm doing my re-venting with ICC. This looks like some great pipe. You moisten up the silicone gaskets and one pipe slides right into the next for a tight seal. My 4" flex liner inserts into the top of the female flex adapter (part # PAF) between three tabs and then you put in 3 screws to hold them together. When I look up inside of it I can still see some slight gaps between the flex liner and the inner part of the ICC adapter. The end of my flex liner is not perfect because I had to trim about 4" off to get this all to line up.
The question is: Should I put a bead of high temp silicone on the inside to seal where the flex liner meets the adapter? I'm thinking it would be a smart thing to do. And then aluminum tape around the top over the screws.
Thanks to all for recommending the ICC pipe.
The question is: Should I put a bead of high temp silicone on the inside to seal where the flex liner meets the adapter? I'm thinking it would be a smart thing to do. And then aluminum tape around the top over the screws.
Thanks to all for recommending the ICC pipe.