Appliance connector hole cutout

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.
19glendale

19glendale

Member
Feb 1, 2015
38
Northern Virginia
Brand new Century S244 here.

I am wondering about the 6 inch steel plate disk from where the hole for the appliance connector was cut. Currently the disk is sitting inside the stove on top of the baffling. Should it be removed/discarded before use?
 
Is there an insulation blanket on top of the baffle? If so that plate might be there as a weight to keep the blanket from getting sucked up onto the flue opening
 
Yes, it's part# 37 - PL63339 BAFFLE INSULATION WEIGHT
 
Status
Not open for further replies.

Similar threads

M
Buck 91 - Liner Connector / Chimney Connector
Replies
4
Views
463
The Hearth Room - Wood Stoves and Fireplaces
ruSSrt
R
R
Insulated flex liner installation and rock wool
Replies
14
Views
2K
The Hearth Room - Wood Stoves and Fireplaces
ruSSrt
R
Don2222
U.S. Stove 5660 - Auger Bushing turns with auger and auger hole for hitch pin ripped.
Replies
2
Views
691
The Pellet Mill - Pellet and Multifuel Stoves
Don2222
Don2222
ctreitzell
Advice To Flatten Warped Baffle In Order To Remove From Firebox
Replies
21
Views
698
The Hearth Room - Wood Stoves and Fireplaces
ctreitzell
ctreitzell
C
Advice on installing cap to top plate/liner setup.
Replies
8
Views
259
The Hearth Room - Wood Stoves and Fireplaces
begreen
begreen
Top Bottom