Hey anyone; I replaced my glass seal this summer, reassembled it, and am now questioning the fit of the gaskets holding the glass to the door frame. After assembly, the metal gaskets angle out from the glass instead of being a level and flush fit. Am I tightening too tightly? The gasket is approximately 1/8 inch thick so I don't think it's too fat. My problem could be how the top and bottom brackets (2 pcs on each side) are orientated for reattachment. Anyone with a cab 50 or similar should be able to answer this. Thanks...
Cab50 door glass gasket fit issue
- Thread starter rickie
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
