I purchased and installed this stove Nov 19th fired it up on highest setting as directed to set paint. Heated up, not much paint smell AND then I turned it to the lowest setting, to my dismay nothing happened sounded just like it was on high. I spent hours reading trying to find info but as you know no much out there. Turned the stove off and called Cleveland Stove and waited for over a week to hear back (Thanksgiving got in the way ) I sent E-mails customer service a few times called again and again, I started trying to figure it out as I sold my older stove, no luck Finally a return call and was told I cannot use the eco2 mode that turns the stove down I need to have it turn off, I will need to invest in ignitors Was told there is very little change in fan speeds from the highest to lowest settings I am so disappointed I was able to turn down fan speeds but only a very little amount. If I set the setting on P1 and down to P4 I can hear a small change in blower speed, air temps do change 225 degrees on low 325 degrees on high temp, that is so hot Im afraid to use it if not home or at night and only on low. Bottom line this little stove could heat 2000 sq ft I hate it and am going to try to return it. I hope the folks at Cleveland read this. I have not tried the wifi I'm having enough trouble with it.