So the Europa 75 is still giving me issues.
two years ago I replaced the feed auger motor. It ran like a champ until about a week ago when the stove shut off in the middle of a negative 30 night.
I pulled the motor and did a bench test. It smoked and sputtered, so it’s fried.
I ordered a generic replacement since original motors are non existent. I tested the new motor on the bench and it turned fine.
I installed it, hit the manual prime button and it won’t turn. I ran the leads that hook to the feed auger to the ash auger and on the manual prime setting it won’t turn either.
is there something I’m missing? I replaced both 500ma fuses on the board, which lights up fine, but still there’s no power to the feed auger. Ideas??
two years ago I replaced the feed auger motor. It ran like a champ until about a week ago when the stove shut off in the middle of a negative 30 night.
I pulled the motor and did a bench test. It smoked and sputtered, so it’s fried.
I ordered a generic replacement since original motors are non existent. I tested the new motor on the bench and it turned fine.
I installed it, hit the manual prime button and it won’t turn. I ran the leads that hook to the feed auger to the ash auger and on the manual prime setting it won’t turn either.
is there something I’m missing? I replaced both 500ma fuses on the board, which lights up fine, but still there’s no power to the feed auger. Ideas??