DV3732 beeping

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
vlbrown

vlbrown

New Member
Dec 29, 2022
3
Seattle area
We recently had a Heat-N-Glo DV3732 fireplace installed. We like it. We got the fancier RCT-MLT remote.

When the Auto-shutoff goes into effect, the fan stays on and the fireplace beeps every 3 seconds. Why does it do this? The only way I have found to make the beeping stop is to turn the fireplace on again and then turn it off manually.
 
Auto-off appears to be a safety function of the remote activated after 9 hours of continuous operation. Manual off and on by the remote is the reset for it.
There is also a safety feature that happens when the remote is over 20ft from the receiver that will turn the flame off and will emit 10 consecutive beeps and then 1 beep every 3 seconds until communication is restored. Low remote batteries can cause distance issues also.
Attached is a manual for the remote control.
 

Attachments

  • RCT-MLT-HHT Remote Control - Accessory Manual.pdf
    599.3 KB · Views: 82
You must log in or register to reply here.

Similar threads

vlbrown
DV3732 Auto-off?
Replies
2
Views
679
It's a Gas!
vlbrown
vlbrown
A
Heatilator NDV3630IL-B Not Lighting
Replies
1
Views
464
It's a Gas!
ARL120384
A
M
Main burner won't light anymore. Before was intermittent and fixed by shaking surround. Thermopile: low volts when switch on, good volts off.
Replies
5
Views
1K
It's a Gas!
Mcburger
M
E
Valor Madrona gas stove not lighting
Replies
4
Views
2K
It's a Gas!
DAKSY
DAKSY
X
Wall switch will not light the heat and glow after 10 seconds of being off
Replies
4
Views
1K
It's a Gas!
xpert66
X
Top Bottom
Back