Englander 25-pdvc problem

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
It does not, it is soldered to the board surface. I had an optometrist go bad on my PDV. I put in a ZIF socket when I replaced it. Be very careful, you only have one or two chances before you most likely ruin the traces on the board.

Eric
 
  • Like
Reactions: Ssyko
Sorry, should have been optoisolator... Stupid Autocorrect on my ipad.

Eric
 
I knew what ya ment ;) and it is also another component to look at on his board. They do tend to go out together
 
You must log in or register to reply here.

Similar threads

D
Piazzetta Sabrina
Replies
0
Views
349
The Pellet Mill - Pellet and Multifuel Stoves
devo1052
D
R
Harman P68 Ignition Problems
Replies
15
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
NS P-68
NS P-68
N
englander 25-pdvc convection blower will stop after about 1-2 hours of running sometimes it will turn back on other time have to reset the machine
Replies
1
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
ericofmaine
ericofmaine
Mammabear
Englander 25 pdv pellet stove not producing heat
Replies
3
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
ARC
ARC
L
Englander 25-PDVC controller questions
Replies
1
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
ericofmaine
ericofmaine
Top Bottom
Back