Harman 52i insert

[Fish On]

so I’m trying to find the right feed rate. This stove is new and I’m not used to what I should be setting.

with my castle I just turned on and that was it.

can anyone share a little on what there settings are on consent burn. I’m burning Vermont pellets. just not used to the digital pad On top of Stove.

 

[Washed-Up]

Usually feed rate at 4 and then the temperature set point, I had to mess around with the temperature set point to find what works for us

 

[Montecarlossfan]

Harman feed rate is merely a maximum the stove can command . The manual should tell you but typically you max out stove temp and blower and feed rate at 4 or so, let it go 15 min, if you have an inch of ash it is set right , if it’s dumping pellets, back it off and wait 15 min and see if it gives the 1” of ash.

My 52i is set to 4.5 and that works for the pellets I buy.

I believe on yours being easytouch it is a percentage…. If pellets spill over drop back a bit .