Harman P68 door question.

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.
J

Jman87

New Member
Sep 21, 2014
67
New Hampshire
Hey,

Harman P68 door, new pellet stove. When I close it, it seems to close fine but it has made a slight divot in the actual stove, almost like it closes a little too tight and has eaton a little metal off.

Is this normal? Anyone else experience this?

Am I being a little too OCD?

Probably :)

Thanks!
 
Are you sure the "divot" hasn't always been there?
There is a small factory-bent section where the door latches...
 
I'm sure. It's not black like the rest of the stove. The edges of the door are a little rough. Can I just file the corners down a little bit?
 
Status
Not open for further replies.

Similar threads

D
What parts will I need for a Harman P68 installation?
Replies
1
Views
193
The Pellet Mill - Pellet and Multifuel Stoves
johneh
johneh
D
P68 Questions for the Braintrust - FINES, Bricks, Glass Clean
Replies
7
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
mtnbiker727
mtnbiker727
L
Grandma Bear door seal issues
Replies
6
Views
677
Fisher Stove Information, Parts, History and More
coaly
coaly
M
Diagnostic assistant needed for a Harman P68
Replies
12
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
Pell
P
M
New Harman P68 smoke smell
Replies
9
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
rickwai
rickwai
Top Bottom