Heatilator CAB50 convection blower

[bollworm]

Hi all, I have a Heatilator Eco-Choice CAB50 pellet stove. The stove turned on and heated up but the convection blower would not turn on.

I) When I bypassed the snap disc #1, the convection blower works fine.

2) I purchased and installed a new Heatilator Eco Choice snap disc 110F-20 SRV230-1220 (from a local part store). The convection blower would not turn on.

Any ideas about this? I suppose that I bought a deficient snap disc #1. Any help and suggestions would be greatly appreciated. Thank you.

 

[johneh]

Stupid question Did you fire up the stove and wait till it warmed up
to see if the convection blower came on?

 

[bollworm]

Stupid question Did you fire up the stove and wait till it warmed up
to see if the convection blower came on?

Johneh, thank you for your help. Yes, I fired up the stove and wait for 18 minutes. Should I wait longer?

 

[johneh]

I fired up the stove and wait for 18 minutes. Should I wait longer?

Depends on how long it takes to heat exhaust to 120
The hotter the fire the shorter the time

 

[bollworm]

I would like to let you know about this stupid mistake – need to install two side panels.

I heated up snap disc #1 and tested it using a multimeter. The snap disc and the convection blower work fine. I realized that I removed two side panels from the stove. When I remove two side panels, it takes a long time to trigger the snap disc because of cold air circulation. When I install two side panels, it takes 20 minutes to start the convection blower. Thank you for your help.

 

[Mt Bob]

I would like to let you know about this stupid mistake – need to install two side panels.

I heated up snap disc #1 and tested it using a multimeter. The snap disc and the convection blower work fine. I realized that I removed two side panels from the stove. When I remove two side panels, it takes a long time to trigger the snap disc because of cold air circulation. When I install two side panels, it takes 20 minutes to start the convection blower. Thank you for your help.

Very good info, thanks!
Stay warm

 

[Skatedog]

Hi all, I have a Heatilator Eco-Choice CAB50 pellet stove. The stove turned on and heated up but the convection blower would not turn on.

I) When I bypassed the snap disc #1, the convection blower works fine.

2) I purchased and installed a new Heatilator Eco Choice snap disc 110F-20 SRV230-1220 (from a local part store). The convection blower would not turn on.

Any ideas about this? I suppose that I bought a deficient snap disc #1. Any help and suggestions would be greatly appreciated. Thank you.

Will the stove running , first unscrew snap disc , take the snap disc connected with wires and hold it against the metal exhaust port just under where it is usually attached . It the fan starts after a few seconds it’s not the snap disc , most like dirt stove , get a brush and clean the inside good