We just bought a home with a Warm Morning Coal stove and cannot seem to get it lit. We have never used a coal stove before and are really at a loss. Any help out there?
lighting a coal stove
- Thread starter rowefam
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
lime4x4
Member
you could either use kindling or most stove shops have this little boxes for starting coal called mice i beleive.There a little white box with a fuse on it.Set the box in the fire box pack a little coal around it and light the fuse.And make sure u close the door real fast cause they really smoke.
Being that we are truly ignorant, does the coal burn in the pan in the bottom of the stove or in the part of the stove where you dump the coal into?
Lots of good goal fire starting and burning information here on hearthnet:
https://www.hearth.com/what/coaltips.html
https://www.hearth.com/what/coaltips.html
Corie
Minister of Fire
coal burns on the grates, the pan in the bottom catches the ashes.
I highly recommend reading craig's primer on burning coal. It will be a big help in getting you started.
Secondly, the easiest way to light a coal fire is charcoal. NOT matchlight and NO LIGHTER FLUID.
Build a small wood fire with light kindling, then proceed to add charcoal (briquettes or lump, doesn't matter). As the charcoal starts burning intensly, you may SLOWLY begin adding coal. While you're doing all of this, make sure the underfire draft control is fully open, as it takes a lot of draft to get coal to light. As the coal you're adding catches (yellow flames, crackling, the actual coal glowing red) begin adding more and more.
After you have a good amount of coal burning hot, fill the stove to capacity. That part is important. Then, after all the coal in the stove is burning, set the air control at a reasonable level and enjoy.
At least twice a day, you'll have to shake the ashes off the coal and add fresh coal. The procedures are well described in Craig's write up.
I highly recommend reading craig's primer on burning coal. It will be a big help in getting you started.
Secondly, the easiest way to light a coal fire is charcoal. NOT matchlight and NO LIGHTER FLUID.
Build a small wood fire with light kindling, then proceed to add charcoal (briquettes or lump, doesn't matter). As the charcoal starts burning intensly, you may SLOWLY begin adding coal. While you're doing all of this, make sure the underfire draft control is fully open, as it takes a lot of draft to get coal to light. As the coal you're adding catches (yellow flames, crackling, the actual coal glowing red) begin adding more and more.
After you have a good amount of coal burning hot, fill the stove to capacity. That part is important. Then, after all the coal in the stove is burning, set the air control at a reasonable level and enjoy.
At least twice a day, you'll have to shake the ashes off the coal and add fresh coal. The procedures are well described in Craig's write up.
- Status
Similar threads
