So after posting here last night I ran flex pipe up the chimney today and made a shutoff with 6 inch cutout for the fireplace damper. Wood stove still only had basement (finished) at 70 degrees. Wife left the door open which goes upstairs about an hour ago. Now the basement is at 77. How and why is that?
Little confused
- Thread starter Bowow
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
I'm not sure I fully understand your post, but perhaps this will help.....
First, basements and underground rooms are often hard to heat - even when finished. Sure, they are easy to get to temps not far from the ground temp (usually 55 or so), but it's hard to really counter the effects of the large cement floors (even if covered) and walls which are not as insulated as upstairs.
That being said, heat often will just stay in a basement or lower room and not rise up the stairway. I've seen this happen a number of times. It makes some sense if you consider that the rest of the house has cold air (relatively) which is pressing down against the basement stairway.
It may help to have a circulation pattern established by the cutting of another grate or opening into the floor from the basement. This may or may not need a powered fan in it. In that case, a lot of hot air may rise up through the grate and then the air from upstairs will drop back down the basement stairs - establishing circulation, which is needed.
First, basements and underground rooms are often hard to heat - even when finished. Sure, they are easy to get to temps not far from the ground temp (usually 55 or so), but it's hard to really counter the effects of the large cement floors (even if covered) and walls which are not as insulated as upstairs.
That being said, heat often will just stay in a basement or lower room and not rise up the stairway. I've seen this happen a number of times. It makes some sense if you consider that the rest of the house has cold air (relatively) which is pressing down against the basement stairway.
It may help to have a circulation pattern established by the cutting of another grate or opening into the floor from the basement. This may or may not need a powered fan in it. In that case, a lot of hot air may rise up through the grate and then the air from upstairs will drop back down the basement stairs - establishing circulation, which is needed.
Cutting a grate into the floor of your living space will probably be against building codes in your area , as the floor its self acts as a fire stop. I would check with your building inspector and your insurance company before you open up the floor.,,,, Just a heads up.
It's ok if you install a fire damper, they're not that expensive and it makes the insurance companies happy.
Put a fan at the top of the stairs aimed down into the basement. On the floor. It will blow cold floor level air down into the basement and the warm air will flow up to displace it upstairs. Do one on the floor in the farthest bedroom doorway down the hall too.
They don't have to be blowing hard. Blow the cold air back toward the stove. The warm air will flow to replace it.
They don't have to be blowing hard. Blow the cold air back toward the stove. The warm air will flow to replace it.
- Status
Similar threads
