I have looked all over!
plug the stove in.. hit start, about a minute click! red flashing light. I went through the flow chart, and when i test the red, white and Black wires i get 5 volts, and no voltage at white and black ...replace push auger ... Is that the auger motor? or the little board on the auger motor? ( or motor with encoder?) are there ohm measurements for all this stuff? I have shunted the vacuum switch . cleaned everything.
plug the stove in.. hit start, about a minute click! red flashing light. I went through the flow chart, and when i test the red, white and Black wires i get 5 volts, and no voltage at white and black ...replace push auger ... Is that the auger motor? or the little board on the auger motor? ( or motor with encoder?) are there ohm measurements for all this stuff? I have shunted the vacuum switch . cleaned everything.
