Pelpro PPC90 controller problem

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
P

Phoenix02

New Member
Sep 9, 2025
1
Ewing, KY
I have a Pelpro PPC90 / TSC90 pellet stove. It will start up, blower come on, show bios version 0.00, then throw an error code for the control board not communicating with the control panel. I tested the ethernet cable between the two and every conductor has continuity, so that's not the issue. Is this the infamous control board failure? Is a new board the only option, or can this one be re-flashed if it has lost its firmware, or are there any other known components on the board that could be causing this?

Thanks!
-Michael
 
You must log in or register to reply here.

Similar threads

Don2222
Pelpro Accutron IV heat level light blinks red when starting but then goes out and stove quits!
Replies
0
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Don2222
Don2222
S
Breckwell P2000i Pellet Stove Problems - Need Help!
Replies
4
Views
3K
The Pellet Mill - Pellet and Multifuel Stoves
spencer.martin
S
H
I REALLY need help
Replies
5
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
Hawke
H
Snowy Rivers
  • Locked
New controller for the "Widdle Stove"
Replies
5
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Snowy Rivers
Snowy Rivers
webfish
  • Locked
General GLOSSARY OF COMMON HEARTH AND HEATING TERMS
Replies
0
Views
8K
Articles
webfish
webfish
Top Bottom