Quadrafire Classic Bay 1200i won't feed pellets

[kekaczor]

Hi all.

My quadrafire 1200 starts up and does a first dumping of pellets and the fire gets going. Unless I hit the reset button, it won't feed pellets after the initial call for pellets. I just recently changed the thermocouple so that I could get it started. It will go through the whole cycle but just won't continue to feed pellets. I've jumped snap disc 1 and 2 as well as the vaccuum switch. Results didn't change. Any suggestions?

 

[Ssyko]

is the wire touching the end of the ceramic protector, and an inch or so inside the edge of the burn pot?

 

[kekaczor]

I've cleaned it well and the thermocouple is in good position. I'll readjust it and try that though.

 

[Overfireinthehole]

Could you have plugged the thermocouple backwards. I don’t think it would feed the initial feed if that were the case but it’s worth
Checking.

 

[kekaczor]

I broke the thermocouple cover while adjusting it so I'm on hold for now.