QuadraFire smoked control board

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.
W

Warren Ness

New Member
Sep 2, 2013
2
I just purchased an older QuadraFire CB1200-1 from a gentleman who gave up on it. The igniter wasn't working so he purchased a new control board. Upon installation the unit ran its checks and when it got to the igniter the board fried. Any ideas about where I should start. I'd like to avoid popping another board.
Thanks
 
Check the ignitor with a Volt Ohm Meter. If it reads zero ohms it is shorted out and can cause problems!
 
Status
Not open for further replies.

Similar threads

B
Can't Figure It Out
Replies
5
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Bigman32hockey
B
RedDig
Quadrafire Santa Fe Got me banging my head against the wall!
Replies
11
Views
3K
The Pellet Mill - Pellet and Multifuel Stoves
RedDig
RedDig
B
No feed
Replies
0
Views
880
The Pellet Mill - Pellet and Multifuel Stoves
bryguy38
B
I
Quadrafire Castile Fans won't stop no pellet drop
Replies
2
Views
957
The Pellet Mill - Pellet and Multifuel Stoves
Former Farmer
Former Farmer
T
King 5502M Won't Run After Auger Replacement
Replies
3
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
Timelord83
T
Top Bottom