Well, I don't know if anybody can help me figure this out. On start up the convex blower slowly and labourously starts to turn. ( just a note, I scrapped, vacuumed, air hosed every inch, inside and out. Blower fins, electric motors)
Slowly gaining speed til almost at the rotation that signals the pellets to start feeding, then it stops, the P comes on, I hit reset then manual start and voila the convex blower blasts on, full speed, then seems to kick down a notch, the pellets feed, ignites and runs all night. Ya think it's the mother board. Any thoughts.
Slowly gaining speed til almost at the rotation that signals the pellets to start feeding, then it stops, the P comes on, I hit reset then manual start and voila the convex blower blasts on, full speed, then seems to kick down a notch, the pellets feed, ignites and runs all night. Ya think it's the mother board. Any thoughts.
