Last year the distribution blower on my us stove 5500m would make alot of noise at start up and quiet down after a little while. I figure barrings are getting bad. I was going to replace it this year but wow they are high. Where is the best place to order parts? Most places are $250 and up. I did see online Rural king has them for $189. This is way cheaper than any other place. Anyone here ever ordered from them?
us stove 5500m blower issue
- Thread starter ymurf
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
Lake Girl
Moderator
They are pricey ... non-OEM blower here: http://www.stove-parts-unlimited.co...t=404&show=12&page=1&f-Convection Blowers=188
Bioburner
Moderator
Well I took the motor apart tonight and got the barrings off. I ordered two from McMaster Carr for $6.00 each. Only issue I may have that I dont quite understand is the barrings that came off the blower have 627s on them. Thats what I ordered but they say they are 7mm hole and the ones I took off measure 6.5mm. But that's the number on the barring so I ordered them.Just hope they are right ones. Better than spending $250 for a new blower.
Bioburner
Moderator
I am lucky in that there is a major supplier of bearings nearby and I just walk in. No cheap stuff either. Hate wasting the time to have to do the job twice.
Well I had to turn a .025 bushing on the lath cause the inside bore was bigger than the blower shaft it wasnt a big deal.Blower is smooth now. And only cost me $12 instead of $250.
- Status
Similar threads
