D
DexterDay
Guest
Going to install my Fathers 25-PDV and I am having trouble finding info on OAK placement.
I have seen where it says it must be 12" away from Exhaust vent?? Does this mean actual distance from end cap termination, or the actual vent where it comes out of the house??
Or it says it must be below termination?? Does this mean it cant go above the vent? Even if its 12" above??
Only reason I ask, is I am going to have to put it above the Exhaust vent.. But it will be about 14-15" above. Well over the 12", but still above it.. The vent will come out horizontally about 2 ft (Vert rise inside house), then the Termination cap pointing down. So it will be about 2.5 ft from termination point, but above it..
Hope this makes sense. Its the only way it can be done because of the layout of the house and Brick and Block below the vent. So it must be above.
I have seen where it says it must be 12" away from Exhaust vent?? Does this mean actual distance from end cap termination, or the actual vent where it comes out of the house??
Or it says it must be below termination?? Does this mean it cant go above the vent? Even if its 12" above??
Only reason I ask, is I am going to have to put it above the Exhaust vent.. But it will be about 14-15" above. Well over the 12", but still above it.. The vent will come out horizontally about 2 ft (Vert rise inside house), then the Termination cap pointing down. So it will be about 2.5 ft from termination point, but above it..
Hope this makes sense. Its the only way it can be done because of the layout of the house and Brick and Block below the vent. So it must be above.