I just received my liner kit today and started piecing the T together. I noticed the connection is not flush. There are visible gaps when I connect the snout to the T and tighten it as tight as it can go. The gaps are not huge but definatley large enough for air/gasses to escape. I can easily see light through from the other side in several spots.
My question is should the snout connection be completely flush?
If this is normal, can I fill in the gaps with high temp caulk, stove cement?
If I can fill it in, wont it just crack and fall out from the hight temps?
Thanks
My question is should the snout connection be completely flush?
If this is normal, can I fill in the gaps with high temp caulk, stove cement?
If I can fill it in, wont it just crack and fall out from the hight temps?
Thanks