Good afternoon. I have a husqvarna 445 chainsaw leaking bar oil when it is in storage and when I run it. The chain is getting oil but I am not sure if it is getting enough. I took the clutch and plate off and I cleaned the pump and oil port but it did not help. Any advice? Also when the bar and chain are back on, is the oil port supposed to push oil only into that small whole on the bar? It seems that the oil port is lined up so it is also pushing a small amount of oil into another hole in the bar. This hole is for the chain adjuster I think. As you can see I don not know much about chainsaws so any advice would be helpful. Thanks.