help its 55 degrees in my house Enviro Omega

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.

3650

Minister of Fire
May 8, 2011
924
midwest
Hello, it's been a while. All has been well up until now. Why do pellet stoves only fail when it's 0 degrees?

My Enviro Omega starts and runs but isn't running right. It will call for pellets then in the middle of the pellet dump it will stop and the light will flash for a bit then dump some pellets. The problem is it isn't building up any heat. If I turn the stove up this scenario just occurs faster.

The flashing light doesn't seem to throw a set number code it's flashing. It just starts flashing for a bit then stops. There is no pattern to the amount of flashes so I can't count a code. As always, any help is appreciated. I know this isn't much to go on but I thought I'd throw it out there.
 
Is the flashing light on the heat output bar ?
or is it the green auger light ?
 
It's the light that says pellets.
 
I'd unplug the stove for a few minutes, to reset the control, and try again.
 
Tried that yesterday with no luck. Guess I'll just have to ride out the rest of the winter in my parka. Thanks for the help.
 
Maybe you should empty the hopper and vacuum out the auger. May sound stupid but maybe it's full of dust. Or maybe the auger motor is going bad. I had to replace my enviro auger once.
 
  • Like
Reactions: vinny11950
Is the stove on a good surge protector? Ant powe outages or spikes?
 
  • Like
Reactions: vinny11950