25-pdvc

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
  1. T

    Englander 25-PDVC overfeeding. Motor or Circuit Board?

    Hello! My stove has been running hot since it was installed 2 years ago. Now that I finished the basement and I am spending time down there, I realized the heat has become a problem. My settings: Year: 2018 Feed: 1 Fan: 1 LFF: 1 LBA: 4 OAT: 1 Restrictor Plate: fully closed Operating Mode: D...
  2. lassygenevra

    Convection blower on pellet stove not turning on.

    We have a 2017 pdvc Englander Pellet Stove. Brand new freshly installed as of September 2018. This fall we cleaned out the whole thing to get it ready for winter use. And it worked fine until 2 weeks ago. It had an issue with shutting off, and the convection blower not working. Trimming the...
  3. D

    Blower not fully working Englander 25-PDVC/55-SHP10

    Hi, my Englander pellet stove is less than a year old and the blower barely works. The speed doesnt seem to spit heat out any faster than a level 3. If you turn it up to lets say 9 and 9, the blower still only pushes hot air out like a level 3. This is ridiculous. I also always get a failure...
  4. R

    25 PDVC and Thermostat trouble

    Hi All, I have a 25-PDVC, 2011, I think, pellet stove and I want to put a thermostat on it. I purchased the Honeywell RTH2300B 5-2 programmable thermostat. I initially tried wiring the stove to the thermostat using the R and W terminals on the stat but the stove never seemed to go down...
  5. A

    25-PDVC Room air blower problem

    Hello, I have searched this site and elsewhere to look for a similar issue to no avail. I have a 25-PDVC and has run well for about five years. Last year I replaced the lower auger and thermostat sensor (rats got in during summer storage). What the problem seems to be is that when the stove...
  6. G

    Englander 25-PDVC Control Board Issues

    Hi all. I'm new here and new to pellet stove ownership. I am working on a stove that I acquired from a friend after we couldn't get it working. The problem is when I plug the stove in, the control board blinks all the LEDs and sometimes pops up an 8 in the heat range window. I replaced the...
Top Bottom