Ok the princess is hooked up and works amazing. I did a break in fire tonight and all I can say is wow. I started a small fire then once that was going I put two small skinny splits got them going good engaged the cat when thermometer went to active then threw on 1 average size 16 inch maple split and gradually turned down the t stat to the dot above low and had fan on low. I did that at 8:30 pm and it just came out of the active mark on the thermometer it's now 11:45 and the stove is still giving off heat. I am amazed how much heat you can get out of one average sized split and two real small kindling like splits. I can't wait til it's cold here and I can load this thing up and see what its got. It's 45* outside 73* inside and I got the back door open. I read in the manual to put furnace cement on stack. How many people have done this? I left the top shroud off to check for leaks and I don't see any.
Blaze king princess insert
- Thread starter Ctd01
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Welcome to the club, do you have an insert? Im going to take a look at my liner and check to see if its tight, I may put some cement on if needed. I suppose it wouldnt hurt.
- Status
