I have a 42 Apex installed in 2018. Blower has always functioned perfectly. Yesterday, on the coldest day of the year, the blower decided it will only blow at the lowest possible speed (barely any output). No matter where the slide switch is positioned the speed will not increase. Had the stove cranked for the entire day yesterday and again today with no change in the blower speed. The only good news is the temp outside is going to get above zero tonight. Any suggestions/ideas are appreciated - Thanks!
Blower Fan Issues
- Thread starter Kearneytitle
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
The most likely culprit is the blower speed control. It should be replaced. This probably could be jumpered out temporarily, but it should not be done without first turning off the power to the fireplace and then only with good knowledge of safe electrical practices.
Similar threads
