well, i'm at it again with my harman accenture insert. my auger will not enguage, but the feed motor light comes on, so i've:
1. testted the motor, and replaced the pressure switch, they are both good. i
2. replaced the gasket on the door, and stood on the hopper lid to make sure it's good.
3. checked the seal on my exaust fan, removed the fines from my slide, and under the burn pot.
4. ran a rod thru my vent tube
any other ideas on why my i cannot get the vaccuum i need?
1. testted the motor, and replaced the pressure switch, they are both good. i
2. replaced the gasket on the door, and stood on the hopper lid to make sure it's good.
3. checked the seal on my exaust fan, removed the fines from my slide, and under the burn pot.
4. ran a rod thru my vent tube
any other ideas on why my i cannot get the vaccuum i need?