When you check the bubble level on the tank should you have ran the splitter a few minutes to get it warmed up prior to checking the level?..thanks
Checking hydraulic fluid level
- Thread starter danthedewman1
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
I check it cold. Some dipsticks are marked for hot and cold levels. The fluid expands when it's hot. A few minutes isn't going to make much difference in fluid temp.
Figure, it should be above the bottom line of the range when cold and below the top line of the range when it's hot.
Similar threads
