Fire Chief FC1000 / Shelter SF1000 - blows biometric damper door off! Do not install a BD!

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
I can't get mine to run for more than 7 minutes with a very hot fire. It seems to push to much air and cool off very quickly
Try putting a higher MERV # filter in...
 
  • Like
Reactions: King of the North
Yes the rear blower is referred to as the “distribution blower” the front blower is the “draft blower”.

Sounds as if you are not getting the stove hot enough. This unit wants to be run really hard aka hot. I could get the front of my stove to glow red.
 
  • Like
Reactions: King of the North
This unit wants to be run really hard aka hot. I could get the front of my stove to glow red.
You shouldn't have to push any stove/furnace that hard. Ever.
Basically brand new and overfired already...and STILL can't keep the fan running...no, just no!
I am literally shocked that nobody has turned these guys in to the CPSC (Consumer Products Safety Commission)
At least Menards has wised up and dropped them.
 
I think the distribution blower would run for at least two hours if not longer. The problem was when the stove went to idle mode. This was the first encounter with a wood furnace. All comes down to fuel... you need dry wood.

Now have the HeatMax II - 1 month in, jury is still out

So far I'm happy with the heatmax, however without this site and knowing about the "mods" to get it to run more optimally I don't believe the furnace would run correctly. Maybe if you had perfectly dry wood you would be ok. But I feel if you put one piece of not so dry wood in the furnace it just kills the secondary burn process and smolders the fire. The "mods" fix this and get it to heat up again and dry that wood out.
 
Now have the HeatMax II - 1 month in, jury is still out
Jury may be out still...but if I recall correctly, 1 month in on the new FC1000, things were already going poorly...sounds to me like the HM II is a big step in the right direction...
 
  • Like
Reactions: Case1030