Is this normal?
- Thread starter Hvac4Life
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Pete Zahria
Minister of Fire
That is how they maintain a set temperature...
feed pellets... stop pellets... feed pellets... stop pellets..
Dan
Ssyko
Minister of Fire
what are your lower 3 settings at? on heat range 1 & 2 you can adjust the LFF and LBA (AOT ALWAYS STAYS ON 1). Do you have the 2 holes under the burn plate plugged? they do that pulsing till you get it dialed in then it only does it at start up.
Last edited:
Pete Zahria
Minister of Fire
Well on heat setting 1, my Englander will look like it is going out, then it ramps up..
the top auger goes on and off, And so on..
so the flames never appear steady.
I will say though, that the flame looks more lively than the one on the right..
But very low when the top auger stops feeding the lower auger...
That one runs all the time.
On startup, it's just pretty high until it goes out of startup mode.
the top auger goes on and off, And so on..
so the flames never appear steady.
I will say though, that the flame looks more lively than the one on the right..
But very low when the top auger stops feeding the lower auger...
That one runs all the time.
On startup, it's just pretty high until it goes out of startup mode.
Similar threads
