Manufactured home wood stove

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here

pinetreefarm

New Member
Dec 29, 2022
2
Bowman, GA
We own a double wide that we renovated for my sister and family. The old fireplace bricks are crumbling and we are seeking options for wood heat. Burning 20 logs a day to put out a tiny amount of heat is ridiculous and replacing interior has been quoted at $400 per side... Is there a back vented mobile home approved wood stove option that could sit on the hearth and be vented up the existing chimney. The only thing I'm finding is the wood heaters like Ashley used to make but people complain the inside falls apart so quickly. I also haven't found those are mobile home approved yet.
 
Nothing can really be recommended that will be “approved” for this application. Your best bet would be to remove the fireplace and the framing, and install a few standing stove. The ceiling is finished above the fireplace behind the the framing. It’s a pretty simple job really, we’ve done it several times.
 
  • Like
Reactions: pinetreefarm
Agreed. The chimney pipe would probably not meet the high temp requirements for a wood stove. Remove the fireplace and get a stove that is mobile approved and install a new class A chimney system.
Often, the flue system height on a manufactured home is a bit short of the 16' minimum some stoves require. If this is so, look at Canadian manufactured stoves that have a shorter 12-13' vent requirement. Regency, Drolet, Osburn, & Pacific Energy have models that will meet this requirement.
 
Although I don't have a manufactured home, my house came with a prefab fireplace with a bad / non-existant door. I pulled the prefab out, including the brick surround and pulled out the entire double wall air spaced chimney which couldn't handle a wood stove. Put in Class A and so on and new wood stove. Nice thing is that the existing prefab had an outside air intake, which I'm sure you will need for code on your new stove. The whole thing was actually pretty simple, the complete demo took maybe half a day and some sawzall work. The tiling of the new area took the longest. Once your class A is in, the install of the stove is very easy.