So, picked up a used stove this weekend, did a total tear down clean yesterday. Had it burning in the garage for 2 hours today on high and then medium setting. Everything was clean and working perfectly. Installed in family room this afternoon, stove ran for another two hours without incident but then fault light came on after a loud snap, and stove went into shut down mode. I turned off the stove and re-started per the manuals after letting it cool off. Fault light is gone but now the convection fan won't turn on. The stove goes through start up mode and gets a good burn but convection blower will not turn on to distribute the heat. Where do I start?
Not sure since it was working perfectly fine.
It's an Avalon Newport PS. And ideas would be greatly appreciated. Thanks!
Not sure since it was working perfectly fine.
It's an Avalon Newport PS. And ideas would be greatly appreciated. Thanks!