I have a 2008 englander 25 pdvc. The top auger quit feeding pellets. Switched the wiring from the bottom auger to the top and now the top works but the bottom doesnt. Would this just be the wiring? Is it replaceable? Please advise
New Issues
- Thread starter ciji.burnup
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
Beaudeen
Member
Check the connection ends on the non-working wiring run...i've had a few that had to be replaced. Give them a good wiggle.
phileefan
Member
It looks as if the upper auger goes thru the vacuum switch and the hopper lid safety switch before going back to your board. The lower auger wiring goes directly to the board. Hope this helps........
- Status
Similar threads
