my stove use to shut off on off for no reason i clean it really good but now it fires up and stays in start up mode untill no pellets are being fed before i cleaned it it was going in demand mode and feeding fine the eye was dirty so i cleaned it and readjust it but still no luck if i put a light where the pellets i get a reading between 1k and 500 ohm i will check the board for cold soldered later any input would be appreciated
problem with profile 30
- Thread starter marc b
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
The Ds
Feeling the Heat
Welcome to the forum. Lots of very knowledgable people here!!
What kind of stove do you have? In order to help, that's a necessary piece of the puzzle. Also.... some punctuation in your posts will help.... hard to read one long run-on sentence
Good luck! Peeps will be along shortly with suggestions
What kind of stove do you have? In order to help, that's a necessary piece of the puzzle. Also.... some punctuation in your posts will help.... hard to read one long run-on sentence
Good luck! Peeps will be along shortly with suggestions
The Ds
Feeling the Heat
OK, I looked it up and it's a Whitfield. Can you add that into your signature? That'll make it easier for future posts too
- Status
Similar threads
