Hi All,
So I am trying to get the hang of the timberline sharpener that was gifted to me by a member of this forum (see other thread), and I am having a bit of trouble!
If you could look at the picture below, you will probably see what I am talking about. Notice how one tooth has a longer hook than the other? That tooth with the longer hook is also about 1.5 cm longer.
Why is this happening? I slowly went down on both sides, the ironic part is the side with the longer hook was the side that took me a couple passes before I could get both sides to sharpen at the same time at the same length.
Do you think the picture looks normal, or do I need to do something different?
So I am trying to get the hang of the timberline sharpener that was gifted to me by a member of this forum (see other thread), and I am having a bit of trouble!
If you could look at the picture below, you will probably see what I am talking about. Notice how one tooth has a longer hook than the other? That tooth with the longer hook is also about 1.5 cm longer.
Why is this happening? I slowly went down on both sides, the ironic part is the side with the longer hook was the side that took me a couple passes before I could get both sides to sharpen at the same time at the same length.
Do you think the picture looks normal, or do I need to do something different?