Vermont Castings Defiant drawing problem

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

carol49

New Member
Hearth Supporter
Jan 25, 2006
2

We have a 3 year old Vermont Castings non-catalytic Defiant wood stove. Previously we had a Vigilant which we used for 22 years. The problem we have with the Defiant is that it does not draw nearly as well as the Vigilant did. Unless it is running hot...stove top 500 to 600F, when we lift the lid to add wood it often puffs smoke out the top.
Along the lower back wall of the inside of the stove are a series of tiny holes that allow air in. Thay are easily plugged by ash and we try to never block them. If these holes were enlarged would that help the draw? Any other suggestions? We always burn dry hardwood.
 
What size stove pipe do you have? I looked at this stove today, the sales man said 8'' pipe is very important for this stove..
 
Status
Not open for further replies.