My new thermometer that goes through the top of the stove into the combustor for some reason moves,in a clockwise position. I've never seen this before. This is a new factory original, baffling. Occurs after being heated up enough to close the bypass, and moved over 50% overnight.
Another Blaze King catalyst thermometer question.
- Thread starter ohlongarmisle
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Dieselhead
Minister of Fire
Yes the entire gauge you can't see it, but in an hour after it's up to temp, it's moved from 12 to 3 the red needle.
BKVP
Minister of Fire
The thermometer does not run into the cat. It sits directly behind the combustor (federal law).
Mine did same thing, but I assumed it was movement thru the cat, around the shaft that caused it. Then, I assumed it was the blowers.
Can't recall my conclusions because I just moved it back.
BKVP
Mine did same thing, but I assumed it was movement thru the cat, around the shaft that caused it. Then, I assumed it was the blowers.
Can't recall my conclusions because I just moved it back.
BKVP
