Hi again everyone. My question this pm is about the installation of the catalytic thermometer. We have the Appalachian Trailmaster 4N1-XL. The port on the top for the thermometer had a screw which we removed. When we put the probe into the hole it did not go down very far when it seemed to hit metal and stopped advancing, about an inch or hair more. Question is, do we cut the probe to where ther meter is flush with the top of the stove or is the meter probe supposed to advance further into the stove? Thanks much for the knowledge. kevandhel :gulp:
Installation of a catalytic thermometer
- Thread starter kevandhel2
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
