i have done a lot of work on my pellet stove the past 5 years and usually the auger clogs and needs to have the loose stuff removed however it is clean.
I replaced the vacuum a few years ago and did the bypass jumper and it also doesnt have it moving.
It had been over feeding lately up until this morning which is usually when the motor gets seized. I noticed it didnt run out of pellets and just stopped so I cleaned it all out but the motor doesn't move at all. I don't think it is a motor issue and wonder what else I might do just to prove its not the motor?
I replaced the vacuum a few years ago and did the bypass jumper and it also doesnt have it moving.
It had been over feeding lately up until this morning which is usually when the motor gets seized. I noticed it didnt run out of pellets and just stopped so I cleaned it all out but the motor doesn't move at all. I don't think it is a motor issue and wonder what else I might do just to prove its not the motor?