Quadrafire 1200 no power to auger motor

[edouglas]

Ok so i have this quadrafire 1200 and i cant seem to get the auger to work. Well it did work until accouple days ago so just looking for some suggestions i have not tried yet.

What does work

1. The combustion blower
2. Power across snapdisk 1 and 2
3. Heater pot if i toss in a hand full of pellets it lights them up.
4. the convection blower if i trip snap disk1 with a propane lighter
5. The Call Light

What doesn't work
1. Auger motor
2. Power across snap disk 3

So what i did try was

1. checked the fuse
2. dropping in a hand full of pellets and yea they fire up.
3. replaced snap disk 1
4. Jumped snap disk 2
5. Measured resistance across snapdisk 3 = 0 ohm's and jumped snap disk3
4. jumped the vac switch
5. unplugged the auger motor took my multi-meter to power in socket - got .06 acv

I would say the motor is dead but its not getting power for some other reason. So i am looking for other reasons that can happen.

 

[mralias]

No power to the auger could be a control board issue. Unplug the stove, re-seat the control board. Make sure contacts are clean. Perhaps this will help.

 

[johneh]

first, jump the auger motor to line voltage and see if it runs
Voltage to the motor is not constant. The auger motor cycles on-off
Maybe the motor is DOA