Hi, thanks in advance for any help. I have a brick single story house built in 1900. It does have 6 chimneys but we only use one. We put in a liner long ago., but it's rotten and I'm about to pull it out. The stove never seemed to draft properly and we quit using it due to health issues. Lots of ash in the house. The bricks would need to be replaced and I do have high temperature bricks from my ceramic kiln I could use, if those would work. It just seems easier to go out through the wall and up the side of the house. I'm not sure how far across I can go or how far up I should go, but it seems it would be easier and way more cost effective. I live at 9700 feet. It would be nice to get it going this winter. Thanks for any advice.
Redo the chimney or just go through the wall?
- Thread starter Cdvorak
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
At almost 10000 feet and a single story house I would want to go straight up. You already had draft problems and adding a 90 will just make them worse. Most stove need a minimum of 13-15 feet chimney height to draft properly and that is at sea level with a straight flue. Adding a 90 and almost 10000 ft elevation means you actually need like 18 feet to draft properly.
EbS-P
Minister of Fire
![[Hearth.com] Redo the chimney or just go through the wall?](/talk/data/attachments/340/340785-98ff54e60c89f5e402c157e972d66204.jpg?hash=--ebH3VjAz)
EbS-P
Minister of Fire
BK states minimum is 15’. I have not seen any stove below 12-13’. I’d rather have the extra length and double wall to boot at 10,000 ft.
Similar threads
