Vent alignment help

[mikkeeh]

Im sure this will sound stupid...but here goes. Im moving my P43 from a basement to an upstairs corner location. Originally, I went straight out to a cleanout "T". The corner install dictates the use of a 45, then out to a "T". Im using duravent....not the pro series. When I lock the cleanout "T", it ends up at 10 oclock or 2 oclock roughly. With the straight out setup, I could adjust the appliance adaptor, but that wont work with the 45. Im sure Im missing something simple...so any advise appreciated.

 

[DAKSY]

I'm thinkin you need an adjustable 45. You will probably hafta tape it tho. Them things are leaky...

 

[P38X2]

How bout one of these? You'll have to screw and silicone it. Not sure about the "hokey" factor, but if it's fastened properly, you should be GTG.
http://www.homedepot.com/p/DuraVent..._kw=&ci_gpa=pla&ci_src=298346236#.Ukt-EeW3OSw

 

[mikkeeh]

I can get a partial lock on it . I suppose I can silicone and screw it together. Just thought someone else had a good solution. I cant be the only person to run into this??