Ash moisture question

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
N

Nvernon91

New Member
Apr 28, 2022
12
Ohio
I have a few cords worth of well seasoned wood ready for this year but I am getting ready to cut some more. My question is I have a ton of white ash trees that died 4-5 yrs ago from the ash borer and they have been dead but are still standing. What type of moisture content can I expect when if I split that and do you think it would be usable this year? I have a lopi evergreen being installed in a month and it comes with a moisture meter so I was hesitant to go buy one knowing I’ll have a free one soon. More curious than anything considering I’ll know for sure soon enough but finally have some time to start splitting for future.
 
it might. I know here in the South it would be good to go more than likely. Just cut and split one and find out
 
I am primarily burning dead ash, in Ohio as well, I would guess if you get it split now it will very likely be OK to burn this winter.
 
Typically the branches and top part of the trunk will be ready to go on a dead standing ash, the bottom part of the trunk often has a little moisture to it, but seems to dry pretty quickly once split...sometimes the bottom of the tree can be punky too, so be real careful and wary when cutting those trees down, you never know what you will find, sometimes the wood is fine, sometimes the bottom 5-8' is totally junk and will just collapse as soon as you touch it...they often break off right at ground level too.
I'd get them all cut/split/stacked ASAP, once stacked and top covered (top only, sides open) the wood will keep just fine for a very long time...but left in the woods they have a limited shelf life for sure...I'd say if they are 4-5 years dead then they might already have a pretty good head start on starting to degrade. For the trees that fell already, the wood in contact with the ground goes bad pretty fast...like in 1 year sometimes...wood that is suspended off the ground will often stay good for some time. (not always though...kinda unpredictable really) sometimes it seems like moisture gets behind the bark and wood just rots...other times it just makes the bark pop off and the wood dries right out and stays nice.
 
Last edited:
  • Like
Reactions: Niro and bholler
I wacked a dead standing ash last year, it had been real sick for several years but still had a few green leaves. No rot at all. The moisture content of the main trunk at ground level was 27 percent! Yeah, baby! Cut it and split it and on Nov. 1 it ill be ready for the wood stove.

I love to cut and burn ash. We have one more to cut down and then the tea party will be all over. All the ash trees on our 105 acres will be dead.
 
the sawmills were flooded with ash around here when they were all starting to die years ago and only offered a couple thousand for over 100 trees. Even though the price was disappointing I should have taken them up on it as I have trees falling on days when it’s not even windy, it’s almost dangerous to be in the woods the past couple years
 
Im in Ohio also and have burned ash standing dead for 5 yrs with no probs. Occasionally the bottom gets a little wet but as stated just split it and it will dry quickly.
 
Man I’ve been cutting dead ash like crazy. Every time I turn around I see another dead ash tree on the property. I should stick the moisture meter on the next one I cut to see what it measures.
 
Simonkenton said:
We have one more to cut down and then the tea party will be all over. All the ash trees on our 105 acres will be dead
Click to expand...
You have no live babies? I see lots of live ash trees, but they are all young ones...seems like once they get 6-8" diameter trunks they are big enough for the EAB to pay attention to it.
Heck, I have a handful of live ash trees on my lil 2 acres...its been some time since I've seen a big one that is healthy though...I hear they exist though (resistant)
 
We were talking about this in another thread a while back. How it might be possible for the young ash to survive the EAB, and maybe grow to be adult trees.

I’ve noticed on my property the EAB seems to like trees about 10” or bigger. And the really big trees are dying left and right. Some of these things are monsters.
 
I am in the North Carolina mountains. I own 48 acres. I only had a dozen ash trees, and all the big ones are dead. Just began dying 4 years ago. In fact there is a 4 inch diameter ash tree right on the edge of my driveway, and it died 2 years ago. I will keep my eyes open for a small one, but I haven't seen a live ash in a year.
 
I just poked a few splits from a standing dead ash tree I cut yesterday. They all read around 27%. This is a tree that was dead but had not lost its bark yet.
 
27 percent. How about that, exactly what I got on my ash tree here in North Carolina.
 
The limb wood on one of the trees I cut down was right at 20%. Ready to burn now! But the wood won’t be burned until 3 winters from now. :)
 
I'm now experiencing lots of dead standing ash in my area, I figure to drop a few in the fall, split and stack and let it go for one year before its ready. FYI when working with these tree's the limb wood is dangerous, like another poster said, these tree's are dropping limb wood on perfect sunny days, had a branch come down and embed itself 8" into the soil, just be aware when working near these tree's.
 
Yeah the ash limbs are definitely widow makers. I wear a forestry helmet when cutting wood, but the big limbs still scare me. Honestly I’m more scared cutting these dead ash then any other trees I’ve cut.

I cut down a dead ash yesterday that fell into a deader (lol) ash on the way down. The tree it fell into was so rotten that it broke into pieces on the way down. I was watching from a distance.
 
That's another thing that stinks about felling these dead standers...when they hit the ground they explode into a million pieces, or at least the branch wood does.
 
The ash I’m cutting all have these tracks under the bark when you rip it off. I’m assuming from the EAB eating it’s way around the trunk. But maybe something else? They have other EAB symptoms, but I’ve never actually seen one of the little beetles.

[Hearth.com] Ash moisture question
 
Classic EAB tracks...and yeah, the lil green buggers have usually moved on to their next victim...I have seen a few over the years though.
 
  • Like
Reactions: DonTee
So does cutting ash that are obviously infected, but still alive (like has half the leaves left) actually kill the beetles/larvae living in that particular tree?

The last pic I posted was from a still living ash I cut down. Here’s a piece of firewood from an already dead ash. A lot more tracks, like shown in your link.

[Hearth.com] Ash moisture question
 
DonTee said:
So does cutting ash that are obviously infected, but still alive (like has half the leaves left) actually kill the beetles/larvae living in that particular tree?
Click to expand...
Not that I know of...unless you get lucky and hit one with the saw ::-)
 
[Hearth.com] Ash moisture question
They are a beautiful green color. Hard to get a pic of them, they see the camera, and fly away.
 
You must log in or register to reply here.

Similar threads

D
Moisture content issues :/
Replies
12
Views
4K
The Wood Shed
trailrated
trailrated
J
Birch Moisture
Replies
31
Views
5K
The Wood Shed
ScottLewis
S
V
Wood Moisture Meter - Which setting shoudl I use for a non-listed wood species
Replies
2
Views
1K
The Wood Shed
Vermonter2011
V
M
How do you all estimate your firewood in cords/BTUs?
Replies
5
Views
2K
The Wood Shed
Highbeam
Highbeam
N
Moisture Content Reading of Hard vs Softwood
Replies
4
Views
3K
The Wood Shed
bunfoolio
B
Top Bottom