auger trouble

[kimwolfe]

I have a Whitfield profile 30. My auger will start to turn but then stops and won't feed pellets. I cleaned the eye and still not working. I bypassed eye and still not working. Checked auger motor turns fine with a power bypass. Im thinking its the high temperature sensor. Please help

 

[kimwolfe]

I have a Whitfield profile 30. My auger will start to turn but then stops and won't feed pellets. I cleaned the eye and still not working. I bypassed eye and still not working. Checked auger motor turns fine with a power bypass. Im thinking its the high temperature sensor. Please help

Need help please

 

[heat seeker]

Does the high temp sensor have a little red button in the center?

 

[miteclipse]

I think this is your manual
http://www.woodpelletheat.com/ProfileStoveManual.pdf

If your Fault light is flashing, check Problem 8 in Troubleshooting section.
If its not flashing, check Problem 3 in Troubleshooting.

It wouldn't let me copy/past.

Also it may appear that you have a PhotoEye Filter as well that needs cleaned.

 

[kimwolfe]

[QfoundTE="heat seeker, post: 2058975, member: 17498"]Does the high temp sensor have a little red button in the center?[/QUOTE]

I think this is your manual
http://www.woodpelletheat.com/ProfileStoveManual.pdf

If your Fault light is flashing, check Problem 8 in Troubleshooting section.
If its not flashing, check Problem 3 in Troubleshooting.

It wouldn't let me copy/past.

Also it may appear that you have a PhotoEye Filter as well that needs cleaned.

I found the eye in the back of my stove but not the filter. Do you have any idea where its at?

 

[kimwolfe]

Does the high temp sensor have a little red button in the center?

No

 

[Stovensen]

I think this is your manual
http://www.woodpelletheat.com/ProfileStoveManual.pdf

If your Fault light is flashing, check Problem 8 in Troubleshooting section.
If its not flashing, check Problem 3 in Troubleshooting.

It wouldn't let me copy/past.

Also it may appear that you have a PhotoEye Filter as well that needs cleaned.

Here we see the relevant troubleshooting sections:






The door switch could very well be the culprit, since it is placed in a hot and dusty environment. And the door switch could be worn out, since it is activated whenever the door is opened/closed, but you will have to check each of the involved switches with an ohmmeter. The high limit switches and the pressure switch are normally closed ( zero ohm ). If you don't have an ohmmeter you can also bypass the switches one by one, but this means more fiddling with wires.
A new door switch can be found for $12 here:
http://www.stove-parts-unlimited.com/Lennox-Micro-Switch-p/h3452.htm

Good luck and take care. Keep us posted.

 

[kimwolfe]

okay, my auger doesn't work on low but won't stop on med?
Thinking control board but i hope not.