Breckwell flue plates dimensions? can't find somes ( when draft is too hight)

[franky932]

Sorry to bring back that issue.......i read some weeks ago about Breckwell flue plates , (SP 1000 -Big E)

Can not find a dealer to sold me the 2. (one for top right.....and one to left top with a notch.)

And i read somewhere in a tread/post (2010) the exact dimension........but did not take a note....!

just past 1 hour to find..........no go........

So someone can help me about that.

TYVM

 

[sbatzold]

https://www.hearth.com/talk/threads/breckwell-big-e-baffle-plates.58725/

 

[franky932]

https://www.hearth.com/talk/threads/breckwell-big-e-baffle-plates.58725/

Thanks a lot....... Q.:1 did you put somes on your's ?...if yes the thicknes of these......

Q 2.: and the attach (clips) is weld on what side ? is there dimension? (approx. )

Thanks again my friend

P.S. : i have a 30 feet (5 inches) liner in my chimney (adaptor 3 to 5) (it was already there and very pricey).......the draft is

powerfull....with no wind....windy? awfull

Brand new stove.......flamme pulling to the right and 4 inches hight at setting 3............damper close

and yours is ok.....??????????????

HAVE A GOOD DAY

 

[sbatzold]

https://www.hearth.com/talk/threads/problem-with-low-heat-output-on-a-breckwell-big-e.47264/

 

[franky932]

I have now the 2 plates......the 1-1/2" notch.as seen on the photos.....is not square....(i think) maybe 1.5 x 1 ?

i am no sure about the pic......i did not made these yet as i write........

what do you think guys?

TYVM