Contour 1000 quadrafire pellet

[Tom Powell]

plug in stove for the 10 - 12 minute exhause fan warm up and it will not turn off, plus the igniter comes on and stays on even when not calling for heat. Stove completly cleaned, all snap disks checked and reset. Green light comes on right away on control module. Are snap disks at fault or is the contrul module faulty?

Thanks for any suggestions.
Tom Powell, MD

 

[tjnamtiw]

Hi, the green light as you probably know, means it thinks it's at 200 degrees. Not a good sign. Is the red light (not the call light) flashing at the same time? The first thing people will tell you to do is UNPLUG THE STOVE, and then remove and reseat the control box in case a contact was dirty. If that doesn't do it, slide on over to iburncorn.com and in the forums go down to the quadrafire section and explain the problem there. Kap is the expert there. I'm an expert (as in 'ex-spurt') too. )