Enviro EF2 wont stay runing after 15 minutes

[Tim11123]

Good day. Looking for some guidance on my enviro ef2. The stove will start up and run for exactly 15 minutes then the auger motor shuts down. Does anyone have any ideas of what I should look for or even bypass to get the stove operational untill I can get new parts for whatever the issue is. Thanks in advance!

 

[johneh]

Sounds like the stove does not reach proof of fire temp
Maybe switch but more likely the sensor is dirty (fly ash)
The sensor is on the exhaust from the stove beside the
convection blower in the manual page 38 number 5
remove the 2 screws and clean the sensor surface and
any ash covering the hole. Fire up the stove and check the operation

 

[Tim11123]

Hey I did that it was quite dirt but stove operated the same.

Sounds like the stove does not reach proof of fire temp
Maybe switch but more likely the sensor is dirty (fly ash)
The sensor is on the exhaust from the stove beside the
convection blower in the manual page 38 number 5
remove the 2 screws and clean the sensor surface and
any ash covering the hole. Fire up the stove and check the operation

 

[johneh]

Try jumping the wires. The stove then should work OK
If it does then replace the sensor

 

[Tim11123]

Try jumping the wires. The stove then should work OK
If it does then replace the sensor

Thanks I'll try that and let you know

 

[Tim11123]

Sorry for the late reply was a busy weekend. I jumped those wires and the stove stays running now. Thank you for your help! Now I just need to wait for the new sensor before I continuously run the stove.