Today I cleaned out my Englander 25 pdvc while I had company over. I vacuumed the ash out of the side pockets. Removed the wear plate and cleaned out the burn plate. Removed the deflection plate and cleaned the channels. Then took my friend outside and proceeded in doing the leaf blower trick. He was amazed at the cloud that came out of it. I put the chimney back together. Then went back into the house and put the stove back together and fired it up. Went outside to put the leaf blower back in the shed.
By this time I noticed I had smoke coming out of the top of the chimney showing that the stove had fired up. Went back inside and noticed that the flame coming out of the burn pot was really lazy and was blowing from right to left. I checked everything to see if I had an air leak going on. Did not find anything. So I shut the stove down again and grabbed the vacuum. Cleaned out the burn pot again. Then I noticed that while I was talking apparently I was not paying to much attention to detail. In my absent mind I put the wear plated back in backwards. I reinstalled the wear plate in the correct position and all is happy and fine. Keep warm next week. Really cold weather to hit the Northeast.
By this time I noticed I had smoke coming out of the top of the chimney showing that the stove had fired up. Went back inside and noticed that the flame coming out of the burn pot was really lazy and was blowing from right to left. I checked everything to see if I had an air leak going on. Did not find anything. So I shut the stove down again and grabbed the vacuum. Cleaned out the burn pot again. Then I noticed that while I was talking apparently I was not paying to much attention to detail. In my absent mind I put the wear plated back in backwards. I reinstalled the wear plate in the correct position and all is happy and fine. Keep warm next week. Really cold weather to hit the Northeast.